Need help?Do you have a question about the jotron MPA 1603 GA and is the answer not in the manual?
General| Brand | jotron |
|---|---|
| Model | MPA 1603 GA |
| Category | Marine Equipment |
| Language | English |
Details measures for achieving full redundancy in the Compact MPA system.
Provides guidance on planning, cabling, and unit placement for installation.
Details planning aspects like SPL, loudspeaker numbers, and cable plans.
Guides on determining the number, type, and tapping of loudspeakers needed.
Explains methods to avoid audible feedback and disturbances during announcements.
Details how to access the system's web-based configuration interface.
Guides on setting a static IP address on the computer for web-interface access.
Provides the default IP address and login credentials for web configuration.
Sets zone assignments, amplifier types, and signal levels for amplifier outputs.
Configures external PA inputs for zone selection, priority, and recording.
Configures microphone stations for zones, priorities, and paging types.
Sets default zone selection and attention tones for PA and EM PA keys.
Configures alarm keys, zone selection, alarm tones, and priorities.
Configures zone, tone, priority, and type (Alarm/Cancel) for external inputs.
Enables AGC and Speech Power Booster for better sound with speech.
Sets alarm block time, PA/EMPA access during alarms, and alarm precedence.
Lists configuration requirements for an IMO/SOLAS compliant setup.
Details the functional operation of the MPA system.
Details how EM PA overrides other audio sources and alarms.
Describes how to initiate and operate Emergency Paging.
Details how PA overrides entertainment but not EM PA or GA.
Describes how to initiate and operate Normal Paging.
Details GA priority over other alarms, PA, and entertainment.
Describes how to initiate and cancel General Alarm.
Describes functional tests for system units.
Provides testing procedures for MPA 1601 and 1643 talk units.
Tests normal paging functionality, zone selection, and attention signals.
Tests emergency paging activation, zone selection, and attention signals.
Tests system functionality when one of the redundant systems is powered off.
Ensures sufficient SPL for alarms and PA messages throughout the installation.
To Next Page
