Chapter 4 ADJUST MENU SETTINGS
4.5 ADJUSTING TT FUNCTION
4-18
Setting Vector Constant
1 Open TT - Vector Constant .
"Vector Constant" menu appears.
Press the cursor key or turn the [MULTI] control to set the vector constant.
The vector constant can be set between 1 and 8.
Set the vector constant value higher to acquire better following up.
Set the vector constant value lower to acquire stable vector.
4.5.2 GATE DISPLAY
Sets the display on/off of target detection area (gate) for target trail function.
Setting for Gate Display
1 Open TT - Gate Display .
"Gate Display" menu appears.
Turns on/off the gate display.
To Next Page
Loading...
