JRC JMA-3334 - Safety Switch; Tune Indicator

Chapter 4 ADJUST MENU SETTINGS
4.6 SCANNER
4-24
4.6.6 SAFETY SWITCH
Use this switch to measure the transmission/reception performance while the scanner
rotation is stopped.
 Setting Safety Switch
1 Open Scanner - Safety Switch .
"Safety Switch" menu appears.
TX-Off : Stops transmission.
(The screen remains in the transmission status.)
Standby : Stops transmission.
(The screen switches to the standby status) (Normal setting)
TX-On : Continues transmission without changes.
(The display unit remains in transmission state.)
(However, errors in bearing signals etc. are to occur due to safety
switch-off.)
Ignore Error : Continues transmission without changes.
(Errors in bearing signals etc. due to safety switch-off are also
ignored.)
Change the setting back to Standby when the work is finished.
4.6.7 TUNE INDICATOR
Set the scale mark when the tune indicator bar reaches the maximum point.
 Tune Indicator
1 Open Scanner - Tune Indicator .
"Tune Indicator" menu appears.