Chapter 4 ADJUST MENU SETTINGS
4.7 I/F DEVICE
4-28
(*) For the GPS compass or other true bearing systems
Select 38400 bps if possible.
A higher baud rate means shorter data output cycle, which results in better course
following performance.
If the system allows setting of data output cycle, set it to 10 ms to 20 ms.
A longer data output cycle results in lower course following performance. This
may affect the radar performance level and the target tracking performance level.
See the relevant sections for details.
[V] Inputting analog speed signals from a log system through synchronization
and steps
By following the procedure described in "Installation section", connect the optional NSK
unit (NCT-4106A) to this equipment.
Then, follow the steps below to make settings.
In "4.7.5 SPEED EQUIPMENT",
set "2. Log".
See the relevant sections for details.
[VI] Inputting digital speed data using a current meter or a Doppler sonar
(IEC61162 or NMEA0183)
By following the procedure described in "Installation section", connect speed equipment
to this equipment.
Then, follow the steps below to make settings.
In "4.7.5 SPEED EQUIPMENT",
set "3. 2Log".
See the relevant sections for details.
To Next Page
Loading...
