JRC JMR-5425-9X - Basic Dialogue Box Operations; Changing Dialogue Box Settings

3-7 Section 3 Common Basic Operations
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
1
3.5 Basic Dialogue Box Operations
When a dialogue box is opened, the dialogue box is in the factory setting state or state at termination of
the previous operation.
The setting can be changed by the following operation.
• Enter a character or a value in the input box.
• Select a setting from the list.
• Select a setting by clicking on the button.
• Select a setting by checking or unchecking the check box.
3.5.1 Changing dialogue box settings
This section describes the basic setting change procedure by using the [Edit and Send AIS Message]
(AIS message editing/transmission) dialogue box as the example.
[Addressed]/
[Broadcast] radio
button:
Select whether a MMSI
message is to be sent or
a broadcast message is
distributed by clicking on
the radio button.
Message input area:
Enter a message
(characters).
[MMSI] box:
Enter a MMSI code
(value).
[Message Category]
list: Select [Safety
Message] or [Routine
Message] from the list.