JRC JMR-5425-9X - Searching for a Port or Service

9-5 Section 9 Chart
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
付録
9.2.3 Searching for a port or service
This function searches for a port or service around the specified coordinates.
When [Search Port or Service] is selected from the context menu that is displayed when you right-click
on the screen, the “Search Port or Service” screen is opened and a search starts.
The following items are displayed on the search screen.
Item
Contents
Setting value
Search Position Displays the specified coordinates under which a port or
a service is searched for. The coordinates when the
context menu was opened by right-clicking are
displayed.
-
Port or Service Select a target to be searched for. Port (always
displayed)
Item that is selected
on the “Search
Service Setting”
screen.
[Search Service
Setting] button
Clicking on this button opens the “Search Service
Setting” screen. To search for a service, check the
check box for the service to be searched for on this
screen. A service can be selected from the Port and
Service combo box.
-
[ ] input box A port or a service is searched for based on the
contents that are input.
Up to 32 characters
No input is
acceptable.
Search Range Specify a search range based on the specified
coordinates.
0.1 to 99.9 NM
Level Specify a level of the port or the service to be searched
for.
A level is assigned to a port or service and the port or
the service is displayed or hidden according to the
display scale. When the [Current Level] check box is
checked, this item cannot be specified.
W (Wide)
Z
A
B
C
D
E
F
G (Detail)
Current Level Sets the level of the port or the service to be searched
for to the level according to the current display scale.
Enable: Checked
Disable: Unchecked
[Search] button When this button is clicked on, search for a port or a
service starts. At completion of the search, the result is
displayed in the search result list.
-