JRC JMR-5425-9X - Using the Set Connection Pattern

C-7 Appendix C Setting the Inter switch
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
27
APP C
C.2.6 Using the set connection pattern
When connecting 3 to 8 radar antennas × 3 to 8 display units, it is possible to save the set connection
pattern in a file. By reading out the saved connection pattern when required, it is possible to quickly
change the connection pattern.
■ Saving a connection pattern
1 After setting a connection pattern, click the [Save/Load file] button of the [Inter Switch]
dialogue box.
The [Connection pattern file] dialogue is displayed.
2 Click the [Save] button.
The [Input file name] dialogue is displayed.
3 Input the file name using the software full keyboard.
4 Click the [OK] button.
The connection pattern is saved, and the connection pattern name is displayed in the
[Connecting pattern files] dialogue.
Memo
 The number of connection patterns that can be saved is up to 10 apart from the connection
pattern set at the time of shipment from the factory (default).

The pattern that is set at factory delviery (Default) cannot be changed.
■ Loading a connection pattern
1 Click the [Save/Load file] button of the [Inter Switch] dialogue box.
The [Connecting pattern files] dialogue is displayed.
2 Click the connection pattern to be loaded.
3 Click on the [Load] button.
The loaded connection pattern is displayed in the [Inter Switch] dialogue.
■ Deleting a connection pattern file
1 Click the [Save/Load file] button of the [Inter Switch] dialogue box.
The [Connecting pattern files] dialogue is displayed.
2 Click the connection pattern to be deleted.
3 Click the [Delete] button.
A dialogue box for confirmation of deleting is displayed.
4 Click the [OK] button in the dialogue box to delete.
The selected connecting pattern file is deleted.