JRC JMR-5425-9X - Setting up Transparency of Echo;Radar Trails; Setting up the Display of TT;AIS Target

Section 11 Setting up Screen View 11-6
11.1.5 Setting up transparency of echo/radar
trails
When you select [RADAR] in the classification pane, the [RADAR] dialogue is displayed in the edit
pane.
[Operation procedure]
Open the radar setting screen by performing the following menu operations.
[Menu] button → View → RADAR
The descriptions of settings are shown in the table below.
Setting Item Description of Setting Setting Value
Transparency of
Echo/Trails
Click on the control on the slider and set up
the transparency of echoes/trails.
0 to 7
0 = Opaque (Nontransparent)
7 = Transparent
11.1.6 Setting up the display of TT/AIS target
When you select [Target] in the classification pane, the [Target] dialogue is displayed in the edit pane.
Configure the settings for TT/AIS targets.
[Operation procedure]
Open the TT/AIS target setting screen by performing the following menu operations.
[Menu] button → View → Target
The descriptions of settings are shown in the table below.
Setting Item Description of Setting Setting Value
CPA Ring (Only
Relative mode)
Enable the display of the CPA ring (circle
created by using the CPA limit setting range as
the radius and own ship as the centre)
To enable: Select.
To disable: Clear.
AIS Symbol Selecting this enables to display the AIS
symbol.
To enable: Select.
To disable: Clear.
Physical AtoN When the AIS symbol is selected and this item
is selected, the display of Physical AIS AtoN
symbol is enabled.
To enable: Select.
To disable: Clear.
Virtual AtoN When the AIS symbol is selected and this item
is selected, the display of Virtual AIS AtoN
symbol is enabled.
To enable: Select.
To disable: Clear.
10
100
AIS Symbol
TT Symbol
AIS Target ID
TT Target ID