JRC JMR-5425-9X - Motor Replacement Procedure for NKE-2103-4;6;6 HS

15-33 Section 15 Maintenance & Inspection
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
23
24
24
26
27
15.5.3.3 Motor replacement procedure for NKE-2103-4/6/6HS
1
Turn Off the safety switch of the radar antenna.
When replacing a motor, ensure
that the safety switch of the radar
antenna is turned Off prior to
commencing the replacement work.
The safety switch is located on the rear
bottom part of the radar antenna.
Turn Off the safety switch.
2 Remove the bolts and open the upper cover.
The upper cover is secured in place with
hexagon head bolts (M8, designed to be
protected from falling out) at four
positions.
After removing the bolts, open the upper
cover until the stay metal fitting stopper
works.
OFF
Safety switch
Four hexagon head bolts
*Closing the upper cover
Release the stay metal fitting stopper,
and then close the upper cover.