JRC JMR-5425-9X - Setting DGPS

13-27 Section 13 Setting up the Operation Mode
１
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
13.19 Setting DGPS
Set a DGPS receiver.
[Operation procedure]
Open the DGPS receiver setting screen by performing the following menu operations.
[Menu] button → Settings → DGPS
The following table shows the setting items.
Setting Item Description of Setting Setting Value
Select Station Set a frequency mode that is used by the beacon
station.
AUTO / Manual
Frequency Set a frequency that is used by the beacon station.
This item can be set only when Manual is selected
in station selection.
275.0 ~ 335.0 kHz
Bit Rate
Set a communication baud rate with a beacon
station.
This item can be set only when Manual is selected
in station selection.
50 / 100 / 200
DGPS Mode Enable/Disable the DGPS mode. To enable: Select
To disable: Clear
DGPS Status
Displays the DGPS status. The status cannot be
edited.
Frequency: Displays the frequency used.
Bit Rate: Displays the modulation speed.
RSSI: Displays the received signal intensity.
-
Send Data Send the setting contents to the DGPS receiver.
During the transmission, “Sending ...” is
displayed as the status. When the transmission
is successful, “Completed” is displayed. When
the transmission failed, “Not Completed” is
displayed.
-