JRC JMR-5425-9X - Setting Cursor, EBL;VRM

13-29 Section 13 Setting up the Operation Mode
１
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
13.21 Setting Cursor, EBL/VRM
Set Cursor, EBL/VRM
[Operation procedure]
Open the Cursor, EBL/VRM setting screen by performing the following menu operations.
[Menu] button → Settings → Cursor, EBL/VRM
The following table shows the setting items.
Setting Item Description of Setting Setting Value
Change distance unit
to "m" with less than
1 NM
Enable/disable synchronisation of the cursor
distance unit and the VRM distance unit.
Enable: Based on the range unit setting, when
VRM is set to the unit within 1 NM/1 sm/1 km, the
VRM distance unit is set to the m unit.
Disable: The VRM distance is displayed according
to the VRM distance unit setting.
To enable: Select
To disable: Clear
EBL/VRM Control
Cursor
Enable the cursor operation by the EBL/VRM dial
when the trackball fails to function.
Enable: Enables the EBL/VRM cursor operation.
The EBL/VRM badge is displayed on
own ship information while the function is enabled,
indicating that the EBL/VRM cursor operation is
enabled.
Disable: Disables the EBL/VRM cursor operation.
To enable: Select
To disable: Clear
Cross-hair Cursor
Pattern
Set up icon of cross-hair cursor type.
Large/Small
Large/Small
Large/Small
Large/Small