JRC JMR-5425-9X - Setting up the Display of C-MAP MAX

Section 11 Setting up Screen View 11-10
11.1.9 Setting up the display of C-MAP MAX
Set drawing of C-MAP MAX.
This setting is allowed only when [C-MAP MAX] is selected in [Chart View].
[Operation procedure]
Open the C-MAP MAX drawing setting screen by performing the following menu operations.
[Menu] button → View → C-MAP MAX
The following table shows the descriptions of the settings.
Setting Item Description of Setting Setting Value
Page1
Mode Select a water depth shadow mode.
The details of a water depth shadow mode are
provided in a separate table below.
Off / Normal / Safe /
Dynamic /
Dynamic Inverted
Highlight Depth
Area
Set a water depth area fill.
On: Fill
Off: No fill (white)
On: Selected
Off: Clear
Minimum Depth Set a minimum value of the water depth shadow fill
range.
This item can be set only when [Dynamic] mode or
[Dynamic Inverted] mode is selected for the water
depth shadow mode.
0m to Maximum Depth
Maximum Depth Set a maximum value of the water depth shadow fill
range.
This item can be set only when [Dynamic] mode or
[Dynamic Inverted] mode is selected for the water
depth shadow mode.
Minimum Depth to
9999 m
Safety Contour Set a safety contour.
This item can be set only when [Safe] mode is
selected as the water depth shadow mode.
0m to 9999 m
Page2
Point of Interested Display/hide the facility information object. Shown: Selected
Hidden: Clear
Land Elevation Display/hide the land elevation object. Shown: Selected
Hidden: Clear
Roads Display/hide the road object. Shown: Selected
Hidden: Clear
Land Elevation
Value
Display/hide the land evaluation value. Shown: Selected
Hidden: Clear
Land Marks Display/hide the land mark object. Shown: Selected
Hidden: Clear
River & Lake Display/hide the river and lake object. Shown: Selected
Hidden: Clear