Section 6 Target Tracking and AIS 6-50
6.11.2 Switching message display
To display transmitted messages:
Click on the [TX Tray] (Transmitted Tray) button.
To display saved messages:
Click on the [Saved Tray] button.
To display received messages:
Click on the [RX Tray] (Received Tray) button.
Unread messages are displayed in boldface.
To filter messages by specifying the transmission method:
To display only messages sent/received by specifying an MMSI code:
Select [Addressed] from the [Message Format] combo box.
To display only messages distributed through broadcasting:
Select [Broadcast] from the [Message Format] combo box.
When messages are not filtered by the transmission method:
Select [All] from the [Message Format] combo box.
To filter messages by specifying category:
To display only safety related messages:
Select [Safety] from the [Message Category] combo box.
To display only routine messages:
Select [Routine] from the [Message Category] combo box.
When messages are not filtered by category:
Select [All] from the [Message Category] combo box.
6.11.3 Sending a message in the message tray after
editing
1 Click the message to copy in the message list.
2 Click on the [Edit] or [Select] button.
When the AIS message tray is displayed by opening the [AIS Message Tray] submenu:
Click on the [Edit] button.
The [Edit and Send AIS Message] dialogue box appears, and the AIS message will be copied to
the [Edit and Send AIS Message] dialogue box. When a message is sent by specifying an
MMSI code, the MMSI code will also be copied:
When the AIS Message Tray was displayed by clicking the [View Tray] button in the [Edit
and Send AIS Message] dialogue box:
Click the [Select] button.
The AIS message will be copied to the [Edit and Send AIS Message] dialogue box. The MMSI
code is not copied by this method.
To Next Page
Loading...
