JRC JMR-5425-9X - Setting up the Display of Range;Bearing Measurement Function

Section 11 Setting up Screen View 11-16
11.1.11 Setting up the display of range/bearing
measurement function
When you select [Tools] in the classification pane, the [Tools] dialogue is displayed in the edit pane.
[Operation procedure]
Open the [Tools] dialogue by performing the following menu operations.
[Menu] button → View → Tools
The descriptions of settings are shown in the table below.
Setting Item Description of Setting Setting Value
Range Rings
(Fixed range rings)
When this item is selected, the range ring display is
enabled.
To enable: Select.
To disable: Clear.
EBL1
Selecting this enables to display the EBL1/EBL2
markers.
To enable: Select.
To disable: Clear.
EBL2
VRM1
Selecting this enables to display the VRM1/VRM2
markers.
To enable: Select.
To disable: Clear.
VRM2
PI
(Parallel index line)
Enable the display of a parallel index line by selecting
the item and select the parallel index line to be
displayed by selecting the line.
To enable: Select.
To disable: Clear.
Selection of parallel
index line
Index Line1 to 8
Expand Cursor
readout &
EBL/VRM
Set an expanded display of cursor information and
EBL/VRM.
On Always expanded for display.
On(5s) Expanded for 5 seconds after the operation.
Off Not expanded.
On / On(5s) / Off
Operating Time on
PPI
Display/hide total operating time of display unit and
TX time of scanner on PPI.
Shown: Selected
Hidden: Clear