Section 4 Range and Bearing Measurement Methods 4-10
To clear the EBL:
1 Press the [EBL] dial.
The context menu is displayed.
2 By turning the dial, select either [EBL1 Hide] or [EBL2 Hide].
3 Press the [EBL] dial.
If [EBL1 Hide] is being selected, the selection of EBL1 is cleared.
If [EBL2 Hide] is being selected, the selection of EBL2 is cleared.
To change the measurement starting point of the EBL:
The measurement starting point can be changed from the own ship's position to another.
1 Press the [EBL] dial.
The context menu is displayed.
2 By turning the dial, select either [EBL1 Control (Carried)] and [EBL1 Control (Dropped)]
or [EBL2 Control (Carried)] and [EBL2 Control (Dropped)].
3 Press the [EBL] dial.
If [EBL1 Control (Carried)] and [EBL1 Control (Dropped)] is being selected, manipulation of
EBL1 is enabled.
If [EBL2 Control (Carried)] and [EBL2 Control (Dropped)] is being selected, manipulation of
EBL2 is enabled.
4 Move the cursor to change the measurement starting point.
5 The measurement starting point is fixed by clicking on it.
Bearing and range from the own ship's
position to the target in this figure:
True bearing 45.0°
Range 0.30 NM
To Next Page
Loading...
