JRC JMR-5425-9X - Page 194

Section 4 Range and Bearing Measurement Methods 4-20
4.6.4.1 Changing the bearing/interval/end point of parallel
index lines in the trackball operation unit (Individual mode)
[Changing the bearing at a clickable trisectional segment position on both sides]
1 Place the cursor on the lines on both sides of the lines that were created by dividing
one of the index lines 1 to 8, which can be clicked, into 3 equal sections and click the
button.
The shape of the cursor changes to
and when the mouse button is clicked, the bearing of
the parallel index lines can be changed.
2 Move the cursor to the bearing to be set.
The bearing of the parallel index lines changes together with the cursor.
3 Click the mouse button.
The parallel index lines are fixed.
[Changing the distance at a clickable trisectional middle position]
1 Place the cursor on the middle line of the lines that were created by dividing one of the
index lines 1 to 8, which can be clicked, into 3 equal sections and click the button.
The shape of the cursor changes to
and when the mouse button is clicked, the interval of the
parallel index lines can be changed.
2 Move the cursor to the interval to be set.
The interval of the parallel index lines changes together with the cursor.
3 Click the mouse button.
The parallel index lines are fixed.
Memo
If a clickable segment is 2 cm or less, the change of interval mode is always activated.
Reference Point
Consistent Common
Reference Point (CCRP)
End point 1
Supplementary line
Reference point on the line
Supplementary line
Supplementary line
End point 2
Change of end
point position
Change of angle
Change of distance
Change of angle
Change of end
point position
Dividing the line segment that can be clicked into 3 equal sections
End points 1 and 2