Section 5 Basic Operation of the Radar 5-10
Memo
If the optimal setting value was lost, it is recommended to reset to
the initial value and tune up again.
The initial setting value is indicated as shown in the figure at right.
Using the automatic rain/snow clutter suppression mode
The rain/snow clutter suppression in accordance with the intensity of rain/snow clutter is possible. Use
this mode when the rain/snow clutter's intensity differs according to directional orientation.
1 Click on the Automatic Rain/Snow Clutter Suppression button.
[AUTO] (automatic) is displayed on the automatic rain/snow clutter suppression
button.
Each time this button is clicked on, the display switches between [AUTO] (automatic) and
[MAN] (manual).
2 Click the left mouse button of the button on the [Rain] (rain/snow clutter adjustment)
slider, drag it with the trackball, and adjust the volume of the echo created by
rain/snow clutter that is displayed on the screen.
Even while AUTO rain/snow clutter is being suppressed, the amount of images can be
fine-adjusted manually.
Canceling automatic rain/snow clutter suppression
1
Click on the Automatic Rain/Snow Clutter Suppression button.
[MAN] (manual) is displayed on the automatic rain/snow clutter suppression button.
Each time this button is clicked on, the display switches between [AUTO] (automatic) and
[MAN] (manual).
AUTO Rain/Snow Clutter Suppression button
To Next Page
Loading...
