JRC JMR-5425-9X - Page 393

13-21 Section 13 Setting up the Operation Mode
１
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
Displaying only the NAVTEX messages that satisfy the specific conditions
When the [Display Filtering for NAVTEX Message] button is clicked on, the [NAVTEX Message
Request] dialogue is opened.
NAVTEX message to be displayed can be filtered on this dialogue.
Setting Item Description of Setting Setting Value
Station-Display
Filtering
Select a base station from which messages are to be
displayed.
When the [Display Filtering] check box is selected,
selection of the check box of each base station is
enabled.
Select a required base station by checking the check
box.
To enable: Select.
To disable: Clear.
Month/Year Only the messages that are received on the selected
month/year are displayed.
Select a required month/year by checking the check
box.
To enable: Select.
To disable: Clear.
Message-Display
Filtering
Select a type of the messages to be displayed.
When the [Display Filtering] check box is selected,
selection of the message type check box is enabled.
Select a required message type by checking the check
box.
To enable: Select.
To disable: Clear.