14-23
Section 14 Adjusting and Setting up Equipment (for Services)
Storing data of the total transmission time and the total motor rotation time in
the radar antenna
1 Click on the [Display Unit TXRX] button.
The total transmission time and total motor rotation time saved in the display unit are saved to
the radar antenna.
If data is saved normally, the data saved in the display unit will be deleted.
When a command is sent from the display unit to the radar antenna, the transmission result is
displayed as follows.
Result waiting state: "Sending..." is displayed blinking at intervals of 1 sec.
When the result is success: "Completed" is displayed.
When the result is failure: "Not Completed" is displayed.
Replacing a TXRX circuit
[Notice] displays the operation procedure and precautions.
1 By clicking on the [TXRX To Display Unit] button, load the data of the total
transmission time and the total motor rotation time from the radar antenna to the
display unit.
2 Turn off the power of the system and replace the TXRX circuit.
3 Turn on the power of the system and write the data of the total transmission time and
the total motor rotation time in the transceiver unit of the radar antenna by clicking on
the [Display Unit To TXRX].
Memo
Make sure that data is written to the transceiver unit of the same radar antenna when the data is
loaded.
To Next Page
Loading...
