Section 15 Maintenance & Inspection 15-30
Remove the motor.
Apply grease to the gear wheel of the
new motor.
Install the new motor in the radar
antenna.
Fasten the hexagon head bolts with
proper torque (380 kgfcm) to ensure
that none of the bolts is left without
being tightened or tightened too
loosely.
5 Connect the motor cables.
Connect each cable back to its original position on the motor driver circuit.
6 Install the cover.
Before installing the cover on the radar antenna, check to confirm that there are no
deformations, cracks or other abnormalities in the packing of the cover. Remove any foreign
matters, dust or other contaminants if found.
Leaving any hexagon head bolts without tightened, or tightening them too loosely, may result in
the waterproof performance of the radar antenna being adversely affected. Fasten the
hexagon head bolts with proper torque to ensure that none of the bolts is left without being
tightened or tightened too loosely.
When the motor replacement is complete, turn on the safety switch of the radar antenna and check if
the equipment operates properly.
To Next Page
Loading...
