JRC JMR-5472-S - Radar System Information

2-15 Section 2 Name and Function of Each Unit
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
1
2.2.12 Radar system information
On this window, verify, adjust, and set a signal tuning status.
The display varies according to the radar antenna type.
Tuning status confirmation
bar display
Displays the tuning indication
value from the transceiver. This
bar is not displayed when the
antenna is a solid-state radar.
Standby/transmission
switching button
Whenever this button is
clicked on, the mode is
switched to "Standby" or
"Transmit". When the power
for this equipment is turned
on, "Preheat" is displayed on
this button.
For the display change at
power ON, refer to Step 3 in
the section "5.2.1 Powering
on and starting"
Transmission pulse length
switching button
This button switches a
transmission pulse length.
For the details, refer to "5.4.2
Changing the transmitter pulse
length".
Transmission band
display
This button displays the
transmission band that is
currently used (X-Band or
S-Band).
Control status and control
antenna display at
inter-switch connection
When this button is clicked on, the
interswitch switching window is
displayed.
For the details of the inter-switch,
refer to "Appendix C Setting the
Interswitch".
Fine tuning adjustment slider
This button checks the tuning status
and slightly adjusts.
For the details, refer to "5.3.3
Adjusting tune".
Tuning mode switching button
Switches the tuning mode between
AUTO (automatic) and MAN
(manual).