Section 15 Maintenance & Inspection 15-46
15.8.2 Restoring backed up data
Use the following procedure to restore backed up data into this equipment.
Connect the external medium (USB memory device, etc.) in which backup data has been saved.
1 Press the power supply button of the operation unit.
The power supply button is lit. A short time later, the Mode Selection screen is displayed.
2 Click on the [Data Backup/Restore] button on the Mode Selection screen.
The [Backup/Restore] dialogue is displayed.
3 Click on the [Data Restore] tab.
4 Select the drive in which backup data has been saved from the drive selection combo
box.
5 Click on the [Start] button.
A confirmation dialogue is displayed.
6 Click on the [OK] button.
Restoration of data from the drive that was selected from the drive selection combo box to the
hard disc of this equipment starts.
If data already exists in the hard disc, an overwriting confirmation dialogue is displayed.
To start restoration, click on the [OK] button.
Memo
• Do not perform any other operations until restoration is completed. Otherwise,
restoration may fail.
• If backup is executed while enough free space is not available in the USB memory
device, the “Error” message is displayed. Secure free space before executing backup.
For the size of the data to be backed up, check the [Usage] column in the “File
Information” list in “14.4.1 Managing storage”.
• If the data to be restored is incompatible with this equipment, the data is not restored.
To Next Page
Loading...
