JRC JMR-5472-S - Setting Own Ships Parameters; Setting the AIS Password

Section 14 Adjusting and Setting up Equipment (for Services) 14-20
14.3.3 Setting own ship's parameters
Set parameter values of own ship by using the [Ship's Parameters] dialogue.
[Operation procedure]
Open the own ship’s parameters screen by performing the following menu operations.
[Menu] button → Service → Installation → Ship’s Parameters
14.3.3.1 Setting own ship's parameters
Set the following items in the [Ship's Parameters] dialogue.
Setting Item
Description of Setting
Setting Value
Ship's Name
Enters own ship's name in the box.
MAX. 20 characters
Length
Enters own ship's length in the box.
1.0 to 1022.0 m
Beam
Enters own ship's beam in the box.
1.0 to 126.0 m
Keel-Trans Enters the distance between the transducer of
the depth sounder and the keel. (Required when
displaying the water depth with the keel fixed)
0.0 to 20.0 m
MAX Speed Limit
Enters the ship's maximum speed in the box.
10.0 to 99.9 kn
14.3.4 Setting the AIS password
Set the AIS password by using the [AIS] dialogue.
[Operation procedure]
Open the AIS password setting screen by performing the following menu operations.
[Menu] button → Service → Installation → Settings → AIS
14.3.4.1 Setting the AIS password
Set the following item on the [AIS] dialogue.
Setting item
Description of setting
Setting value
Setting Password To change Voyage data from the external
device, JHS-183 requires the password.
When the AIS password is changed,
change this setting value.
When the password is not required, this
setting value is ignored in (JHS-182).
Up to 32 characters (numeric
value only)