Section 10 Creating a User Map 10-18
10.6.2.1 Creating a vertex by entering the position
1
Click on the [Enter POSN] button on the drawing toolbar.
The [Enter Position] dialogue appears.
2 Enter the values of latitude and longitude of the vertex of the object in the [Position]
box and click on the [Enter] button.
The position of the vertex of the object is determined.
The [Bearing] box and the [Distance] box are enabled.
3 Enter the values of the latitude and the longitude of the next vertex in the [Position]
box. Alternatively, enter the bearing from the vertex that was determined immediately
previously in the [Bearing] box and the [Distance] input box.
4 Click on the [Enter] button.
5 Determine the positions of 3 or more vertices by repeating Steps 2 and 3.
6 Adjust the parameters on the object property dialogue.
7 To create an object in another position continuously, click on the [New] button of the
[Enter Position] dialogue and repeat Steps from 2 to 6.
To Next Page
Loading...
