Section 15 Maintenance & Inspection 15-44
15.7 Updating Help Data
This section describes updating of help data of this product.
When Help is updated, the currently active mode is terminated automatically. Complete the
necessary operations such as the saving of settings prior to the start of update.
[Operation procedure]
Open the Software Update screen by performing the following menu operations.
[Menu] button → Maintenance → Software Update
1 Set the USB memory device containing update data.
2 Click on the [Help Install] button.
A file selection dialogue is displayed.
3 Select the drive containing update data from the [Drive] combo box.
4 Select the folder containing update data from the folder tree and check the help file to
be updated from the file list.
5 Click on the [Install] button.
Installation starts and a screen is displayed indicating that installation is being performed.
Wait until installation is completed.
At completion of installation, an installation completion screen is displayed.
6 Click on the [OK] button.
Memo
• When the [Cancel] button is clicked on during installation, installation of subsequent files
is cancelled after the installation of the file that is currently being installed is completed.
• When the selected update file alreay exists, a screen is displayed indicating that the file
has been installed. End the operation by clicking on the [Cancel] button.
To Next Page
Loading...
