JRC JMR-5472-S - Initialising Menu Setting Values; Initialising Equipment Configuration; Initialising the Settings Other than Equipment Configuration; Backing up the Setup File

Section 14 Adjusting and Setting up Equipment (for Services) 14-24
14.4.3 Initialising menu setting values
Initialise menu setting values. To reflect the setting, restart the unit.
[Operation procedure]
Open the initialisation execution selection screen by performing the following menu operations.
[Menu] button → Service → Maintenance → Initialisation
14.4.3.1 Initialising the settings other than equipment
configuration
1
Click on the [Set Default] button of initialisation (all the settings except the equipment
configuration).
An initialisation and restart confirmation popup window is displayed.
2 To execute initialisation of the settings other than the equipment configuration, select
the [OK] button.
The application restarts and initialisation is executed.
When [Cancel] is selected, the initialisation execution selection screen is displayed.
14.4.3.2 Initialising equipment configuration
1
Click on the [Set Default] button of initialisation (equipment configuration).
An initialisation and restart confirmation popup window is displayed.
2 To execute initialisation of the equipment configuration, select the [OK] button.
The application restarts and initialisation is executed.
When [Cancel] is selected, the initialisation execution selection screen is displayed.
14.4.4 Backing up the setup file
Output the setup file in this equipment to an external storage device such as USB memory device.
[Operation procedure]
Open the setting file backup execution screen by performing the following menu operations.
[Menu] button → Service → Maintenance → Settings Backup
14.4.4.1 Backing up the setup file
1
Select a backup destination folder path in the text box of [Main Drive C: >>].
Select a backup destination folder from the [Browse] button or select a folder path by directly
entering it on the software keyboard.
When the selected folder does not exist, a new folder is created.
2 Click on the [Backup] button.
During backup processing, [Processing ….] is displayed under the [Backup] button.
When backup failed, an error message is displayed on the popup window.