JRC JMR-5472-S - Setting up the Display of Own Ship Symbol

Section 11 Setting up Screen View 11-2
11.1.1 Setting up the display of own ship symbol
Configure the setting for own ship symbols.
[Operation procedure]
Open the display setting screen of the own ship symbol by performing the following menu operations.
[Menu] button → View → Own Ship
Vector display at primary position
In the own ship symbol, COG (Course Over the Ground) vector, HDG (Heading) vector, and heading
line can be displayed. The COG or HDG vector can also be displayed by the length proportionate to
the current ship speed in minute by the setting. For example, when the vector length is set to 10
minutes, the vector tip is at the predicted position after 10 minutes if the ship is assumed to navigate at
the current speed.
COG vector
HDG vector
Vector Time Mark
(Vector time mark)
Time (own ship’s vector length)
Time (own ship’s vector length)
Vector Time Mark
(Vector time mark)
AIS Filter
Stabilisation indicator
Sea stabilised vector
Ground stabilised vector
Vector Time Mark
Stern Line