C-5 Appendix C Setting the Inter switch
[Edit Name] button When this button is clicked, a dialogue box is displayed for changing the
names of the radar antennas and display units. Regarding the operations
in the [Edit name] dialogue box, refer to "C.2.5
Changing the name of
radar antenna or display unit".
[Save/Load file] button When this button is clicked, the [Connection pattern file operation]
dialogue box is displayed. The current connection pattern can be saved
in the file or the connection pattern that has been saved previously can
be loaded. For details of the [Connection pattern file operation] dialogue
box, refer to "C.2.6 Using the set connection pattern".
[Set] button When this button is clicked, the information of the set connection pattern
is transmitted to the Inter switch.
Memo
When a master or slave display unit button in which the error notification mark ( ) is being
displayed, the [Set] button becomes disabled.
For the details of error notification marks, refer to " C.2.3.1 About equipment defect mark ( )
and error notification mark ( )".
C.2.3.1 About equipment defect mark ( ) and error notification
mark ( )
■ Equipment defect mark
This mark is displayed when the power supply of the radar antenna or the indicator unit is OFF or faulty.
Check the cause and take corrective action.
■ Error notification mark
This mark is displayed when there is some error in the settings of a radar antenna or a display unit.
Check the cause and take corrective action.
The master display unit does not exist or is faulty
although the slave display unit is connected.
Connect the master display unit.
The master or slave display unit that is
connected is not permitted to be connected to a
radar antenna.
Check the setting by selecting [Service] -
[Installation] - [Settings] - [Inter switch] on the
menu and permit the connection to the display
unit or connect another display unit whose
connection to the radar antenna is permitted.
To Next Page
Loading...
