Section 4 Range and Bearing Measurement Methods 4-12
1 Click on the measurement starting point button of EBL2/VRM2 and select [D].
2 Align the cursor with “point A” of the two points to be measured and then click it on.
3 Enable the movement of EBL2 by clicking on the EBL2 line.
4 Align the cursor with bearing “point B” of the two points to be measured and then click
it on.
5 Enable the manipulation of VRM2 by clicking on the [VRM2] button.
6 Move the intersecting point marker on the dotted line of EBL2 by the cursor and align it
with point B.
The range and bearing between the two points are displayed.
Measurement starting point button
To Next Page
Loading...
