Section 11 Setting up Screen View 11-14
Setting Item Description of Setting Setting Value
Highlight Contour Set a specified contour (contour to be highlighted). Up
to seven contours can be registered.
-
Contour Specify a water depth of the contour. When a numeric
value is entered and the [▼] button is pressed, water
depth values that can be set are retrieved and
displayed. A contour can be input by selecting a
0 to 9999m
Add When this button is clicked on, the water depth value
that was specified in the text box is registered in the
-
Delete Delete the column that is selected by selecting the
check box in the water depth list.
-
Contour list Display the contours of the water depths that are
registered in the list. A colour and a line type can be
specified for each contour that is displayed. When Off
is specified for a colour, the contour will be hidden.
[Colour]
White / Grey / Amber /
Magenta / Blue /
Cyan / Green / Yellow /
Orange / Dark Red /
Off
[Line Type]
Solid line / dotted line /
dashed line /
chain line /
two-dot chain line
chain line2
Display Priority Set up a drawing order of the contour.
Contour : Draw the contour over the echo.
Echo : Draw the contour under the echo.
Contour
Echo
To Next Page
Loading...
