EasyManua.ls Logo

JRC NCR-333 - 6.2.7.4 Select message list

JRC NCR-333
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
I d. Save the message
Save the message
The currently open message can be saved.
The saved message is
permanently stored in the data
memory.
Procedures
1) Press the 8
key.
The sub screen appears.
2)
Select the ·[SAVE MSG]", and press the
lEN]
key.
3) •ARE YOU SURE?" is displayed. Select the "[OK]",
and press the IENlj key.
rNow
SAVING ... " is
displayes on the sub screen.)
To
return to the sub screenl
(S~T
UP), select
"[CANCEL]"
and press the
EN
key.
4) After message
sav~as
been completed, press
the
IENlj key
or
the
1£b.B1
key.
KEIHIN
KO.
TOKYO
EAST
PASSAGE.
DAYTIME
DAILY
UNTIL
08
JULY
2006
SET
UP
*
[NEXT
MSG]
[PREV.
MSG]
[SAVE
MSG]
ARE
YOU
SURE?
[CANCEL]
~
E
MSG*
SAVE
OK
[CANCEL]
El@il
- The message that is not saved (the stored message) is automatically erased from the data memory
about
70 hours after receiving.
-
50 messages
of
an average length
of
500 characters can be saved
in
each channel.
The
message cannot
be
saved
When the saved message in the data memory is full, the
sub screen is
displayed as shown
in
the following figure,
and the status bar shows which
channel cannot
be
saved ( 0 mark).
Refer to
•c. Put a check mark" (6.2.7.2 Message list 1)
for
explanation
of
the display
of
the status bar.
Save again after unsaving the unnecessary message in
message
list when unable to save a message.
6-10

Table of Contents

Other manuals for JRC NCR-333

Related product manuals