JUKI IP-420 - To Perform Re-Sewing from the Start

– 46 –
1
Release the error.
Press RESET button
A
to release the error.
(2) To perform re-sewing from the start
3
Return to the origin.
When RETURN TO ORIGIN button
F
is pressed, the
pop-up is closed, the sewing screen is displayed and the ma-
chine returns to the position of the start of sewing.
4
Perform again the sewing work from the start.
When the pedal is depressed, sewing starts again.
2
Perform thread trimming.
Press THREAD TRIM button
B
to perform thread trim-
ming.
When PRESSER UP button
G
is pressed, the presser
goes up. Turn OFF the power since the operation afterwards
cannot be performed.
When thread trimming is performed, INTERMEDIATE
PRESSER UP/DOWN button
C
, FEED BACKWARD
button

D
, FEED FORWARD button
E
, and
RETURN TO ORIGIN button
F
are displayed in the
screen.
1. When the presser is raised and the operation is
stopped on the way because of the trouble of for-
getting to enter the bobbin case or the like, press
PRESSER UP button
G
and turn OFF the
power.
2. PRESSER UP button
G
is not displayed when
the presser is of pneumatic type.
A
B
G
C
F
E
D