5. Repeats steps 4 and 5 on the opposite side of the router.
6. Have one person grasp both sides of the router, lift it, and position it in the rack so that the front bracket
is aligned with the rack holes.
7. Have a second person secure the front of the router to the rack using four mounting screws (and cage
nuts and washers if your rack requires them.) Tighten the screws.. See Figure 31 on page 107 and
Figure 32 on page 107 for examples of connecting the mounting rails and blades.
Figure 31: Attach 1 U Router to Rack
Figure 32: Slide Mounting Rail onto the ACX5096 Rear Mounting Blade
8. Continue to support the router while sliding the rear mounting-blades into the channel of the side
mounting-rails and securing the blades to the rack. Use the four mounting screws (and cage nuts and
washers if your rack requires them) to attach each blade to the rack. Use eight front-mounting screws
for the ACX5096. Tighten the screws. See Figure 33 on page 108.
107
To Next Page
Loading...
