JVC XL-R5010BKC User Manual

6
English
English
CD Control Operation Buttons
PLAY MODE: Press repeatedly to select one of the play modes for
the 3-CD changer. (see page 16, 17)
CD EDIT: Press to select either Listening Edit or Program
Edit recording mode. (see page 26, 27)
CD REC: Press to perform synchronized recording of the
currently selected CD in the 3-CD changer.
(see page 23, 24)
STOP7: Press to stop play of the selected disc in the 3-CD
changer. (see page 11)
PLAY3: Press to start play of the selected disc in the 3-CD
changer. (see page 11)
PAUS E8: Press to pause play of the selected disc in the 3-CD
changer. (see page 11)
PHONES (Headphones) Jack
Use this jack to connect headphones (not supplied) to the unit.
PHONES LEVEL (Volume) Control
Use this to adjust the volume being output to headphones con-
nected to the unit.
Note
In this manual, procedures using buttons on the front panel of the
unit are depicted by the name of the button in capital letters with
the button illustration immediately after it. Procedures using the
buttons on the remote control are depicted by the button illustration
with the name of the button in small letters and parentheses imme-
diately after it.
Example: CD Control PAUSE 8 button Front panel 8 (pause)
button Remote control
Remote Control Sensor
This sensor receives commands from the remote control.
XL-R5010BK.book Page 6 Monday, June 4, 2001 11:40 AM

JVC XL-R5010BKC Specifications

Power

power requirements	120V, 60Hz
power consumption (power ON mode)	40W
power consumption (STANDBY mode)	5W

Output Terminals

analog output	2V/5kΩ
headphones output	4mW/32Ω
digital optical output	–21dBm - –15 dBm

Weight and Dimensions

dimensions (W x H x D)	435mm x 127mm x 334mm
mass	6.3kg