TECHNICAL DESCRIPTION Kamstrup 162M/382M
5512-1040 GB/05.2012/Rev. C1
29
3.9 Alarm handling/Push alarms
The meter can be configured to give alarms when specific events are registered by the meter. Events that can be
configured to generate push alarms are:
- Magnetic detection
- Tamper detection
- Internal meter error
- Under and over voltage detection
- Missing phase voltage detection
The alarms will be transmitted via Kamstrup radio communication (if the meter is with Radio) for use in Kamstrup
AMR systems, or on the module port. For further details about alarms and configuration, please contact Kamstrup.
3.10 Load control
As an option it is possible to mount a two relay load control module in the meter. The relays can be used to
control (On/Off) external installations. The control of the relays can be done by:
- Predefined (configurable) Load control tables - managed by the meter.
- By remote command – managed by system.
See more about configuration of the load control in section 10.4.
To Next Page
Loading...
Need help?
General
