EasyManuals Logo

KaVo OP 3D Vision User Manual

KaVo OP 3D Vision
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
5-5
IEC Command Codes
032-0358-EN Rev B
X-ray On: Typically equals 1. 0 to (Ticks per frame - 1)
X-ray Off: Greater than X-ray On and less than (Ticks per frame - 1)
Set as needed for desired length. 50,000 = 1 (ms)
Panel Readout: 0 to (Ticks per frame - 1). Typically set the same as
X-ray Off, except for continuous X-ray mode.
Pulse Mode: 0 or 1. If not entered, defaults to 0.
0 = 200 microsecond pulse for panel blanking and valid frame.
1 = either a 5msec pulse for valid frame or 3msec for panel blanking
Tube Range: If not entered, defaults to zero.
0 = 120 KV tube, 1 = 90 KV tube
X-Ray Commands
XCN Performs a cine X-ray acquisition for the number of frames requested at the
‘Ticks Per Frame’ rate as setup in the X-ray register.
Command syntax: XCN Frames Watchdog
Frames: 1 to 1024
Watchdog: 0 = disabled, 1 = enabled
XCT Perform a CT scan for requested distance, speed, and watchdog settings.
Command syntax: XCT Distance Speed Watchdog
Distance: 1000 to 668563
Speed: 1000 to 65000
Watchdog: 0 = disabled (default), 1 = enabled
XIP Performs a Panoramic scan for the requested parameters.
Command syntax: XIP Distance Speed PlatformOffset PlatformStartSpeed
PlatformStopSpeed RampReduction Watchdog
Distance: 1000 to 668563
Speed: 1000 to 70000
Platform Offset: 1 to (Distance - 25000)
Platform Start: 1000 to 54000
Platform End: 1000 to 54000
Ramp Reduction: 0 to 250
Watchdog: 0 = disabled, 1 = enabled
XP Performs an exposed X-ray acquisition for the number of frames requested at the
‘Ticks Per Frame’ rate as setup in the X-ray register.
Command syntax: XP Frames Watchdog
Frames: 1 to 1024
Watchdog: 0 = disabled, 1 = enabled
Miscellaneous Commands
BD Get Board Information
Command syntax: BD
Retrieves the board component versioning.
Results returned in format: OK KRL:x UBT:x FID:x SWB:x
KRL: Linux kernel version (short)
UBT: U-Boot version (short)
FID: 1210 Board Flash (EEPROM) Chip System ID
SWB: ROMFS Software Build version (HG-ID Date Time)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KaVo OP 3D Vision and is the answer not in the manual?

KaVo OP 3D Vision Specifications

General IconGeneral
BrandKaVo
ModelOP 3D Vision
CategoryDental equipment
LanguageEnglish

Related product manuals