Introduction
The IEEE-488.2 standard requires specific information about how the Model 2182
implements the standard. Paragraph 4.9 of the IEEE-488.2 standard (Std 488.2-1987) lists the
documentation requirements. Table G-1 provides a summary of the requirements and provides
the information or references the manual for that information. Table G-2 lists the coupled
commands used by the Model 2182.
The Model 2182 complies with SCPI version 1991.0. Table 14-2 through Table 14-11 list the
SCPI confirmed commands and the non-SCPI commands implemented by the Model 2182.
Table G-1
IEEE-488 documentation requirements
Requirements Description or reference
(1)
(2)
(3)
(4)
(5)
(a)
(b)
(c)
(d)
(e)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
IEEE-488 Interface Function Codes.
Behavior of 2182 when the address is set outside
the range 0-30.
Behavior of 2182 when valid address is entered.
Power-On Setup Conditions.
Message Exchange Options:
Input buffer size.
Queries that return more than one response
message unit.
Queries that generate a response when parsed.
Queries that generate a response when read.
Coupled commands.
Functional elements required for SCPI commands.
Buffer size limitations for block data.
Syntax restrictions.
Response syntax for every query command.
Device-to-device message transfer that does not
follow rules of the standard.
Block data response size.
Common Commands implemented by 2182.
Calibration query information.
Trigger macro for *DDT.
See Appendix F.
Cannot enter an invalid address.
Address changes and bus resets.
Determine by :SYSTem:POSetup (Section 15).
256 bytes.
None.
All queries (Common Commands and SCPI).
None.
See Table G-2.
Contained in SCPI command subsystems tables
(see Table 14-1 through Table 14-12).
Block display messages: 12 characters max.
See “Programming syntax” in Section 11.
See “Programming syntax” in Section 11.
None.
See “DISPlay subsystem” in Section 15.
See “Common Commands” in Section 12.
Not applicable.
G-2 IEEE-488 and SCPI Conformance Information