11-2 SCPI Tables
SCPI command subsystems reference tables
Tables 11-1 to 11-7 summarize the commands for each SCPI subsystem. The following list in-
cludes the SCPI subsystem commands and the table number where each command is summarized.
• Table 11-1 DISPlay command summary
• Table 11-2 FORMat command summary
• Table 11-3 OUTPut command summary
• Table 11-4 SENSe command summary
• Table 11-5 SOURce command summary
• Table 11-6 STATus command summary
• Table 11-7 SYSTem command summary
General notes
• Brackets ([ ]) are used to denote optional character sets. These optional characters do not
have to be included in the program message. Do not use brackets in the program message.
• Angle brackets (<>) are used to indicate parameter type. Do not use angle brackets in
the program message.
• The Boolean parameter (<b>) is used to enable or disable an instrument operation. ON
or 1 enables the operation, and 0 or OFF disables it.
• Upper case characters indicate the short-form version for each command word.
• Default parameter — Listed parameters are the *RST default. Parameter notes are locat-
ed at the end of each table.
• SCPI — A checkmark (√) indicates that the command and its parameters are SCPI con-
firmed. An unmarked command indicates that it is a SCPI command but does not con-
form to the SCPI standard set of commands. It is not a recognized command by the SCPI
consortium. SCPI confirmed commands that use one or more non-SCPI parameters are
explained by notes.
To Next Page
Loading...
Need help?
General
