DISPlay, FORMat, and SYSTem 10-3
An indefinite block message must be the only command in the program message or the last
command in the program message. If you include a command after an indefinite block message
(on the same line), it will be treated as part of the message and is displayed instead of executed.
Use the next command to enable the text message mode.
C. DISPlay:TEXT:STATe <b> Control message
Parameters :<b> = 0 or OFF Disable text message
1 or ON Enable text message
This command enables or disables the text message mode. When enabled, the text message
is displayed. If no message is defined, a string of 32 spaces is displayed. When disabled, the mes-
sage is removed from display. The display returns to the normal display state.
A text message remains displayed only as long as the instrument is in remote. Taking the
instrument out of remote (by pressing the LOCAL key or sending GTL) cancels the message and
disables the text message mode.
To Next Page
Loading...
