6
GPIB Operation
• Introduction — Describes the IEEE-488 (GPIB) standards used by the power supply.
• GPIB bus connections — Shows how to connect the power supply to the GPIB.
• Primary address — Explains how to check and/or change the primary address for the bus.
• Output format — Covers the output formats for readings sent over the bus, and output
types for the response to *IDN?.
• General bus commands — Documents general bus commands that pertain to all GPIB
instruments.
• Programming syntax — Provides syntax information for sending command and SCPI
commands over the bus.
To Next Page
Loading...
