Emulation Commands C-5
Fluke PM2811 power supply emulation commands
Most of the Fluke commands are already covered in the SCPI command reference section.
However, a few commands were added to specifically emulate the Fluke power supply. These
commands are listed in Table C-2. Details on these commands follow the table.
:VOLTage:PROTection <NRf>
No operation for the power supply
:VOLTage:PROTection?
Returns meaningless response message
Description
These commands are used to set an output voltage limit for the Fluke
PM2811 Power Supply. The power supply does not support voltage limit.
These commands can be sent to the power supply without causing an error,
but are, in effect, NOOPs (no operations). The query command will return a
value, but it is meaningless.
The complete SCPI command paths for these commands are shown in Table C-2.
NOTE
The query response is affected by the GPIB output format. For decimal formats, the
response has the specified decimal places, otherwise it is in exponential format.
Table C-2
Fluke commands used to control Model 2303/2303B/2303-PJ
Command Description *RST Default
[:SOURce]
:VOLTage
:PROTection
[:LEVel] <NRf>
[:LEVel]?
:INSTrument
:STATe <b>
:STATe?
:SOURce Subsystem:
Path to configure voltage:
Path to set voltage limit:
NOOP (no operation). Power supply does not use voltage
limit.
Returns a meaningless value.
Path to control power supply output:
Enable or disable power supply output.
Query state of power supply output.
OFF
To Next Page
Loading...
Need help?
General
