Getting Started 1-3
Inspection
The power supply was carefully inspected electrically and mechanically before shipment.
After unpacking all items from the shipping carton, check for any obvious signs of physical
damage that may have occurred during transit. (Note: There may be a protective film over the
display lens, which can be removed.) Report any damage to the shipping agent immediately.
Save the original packing carton for possible future shipment. The following items are included
with every order:
• Model 2303/2303B/2303-PJ High Speed Power Supply with line cord
• Quick Disconnect Output/DVM Input Connector
• Accessories as ordered
• Certificate of calibration
• Model 2303/2303B/2303-PJ User’s Manual (P/N 2303-900-00)
• Model 2303/2303B/2303-PJ Service Manual (P/N 2303-902-00)
If an additional manual is required, order the appropriate manual package. The manual pack-
age includes a manual and any pertinent addenda.
Any improvements or changes concerning the instrument or manual will be explained in an
addendum included with the manual. Be sure to note these changes and incorporate them into
the manual.
Options and accessories
The following options and accessories are available for the power supply.
• 2304-DISP remote display unit
• Shielded IEEE-488 cable, 1m (3.3 ft) (P/N 7007-1)
• Shielded IEEE-488 cable, 2m (6.6 ft) (P/N 7007-2)
• Single fixed rack mount kit (P/N 4288-1)
• Dual fixed rack mount kit (P/N 4288-2)
• IEEE-488 Interface/controller for the PCI bus (P/N KPCI-488)
• IEEE-488 interface card for IBM PC/AT (full slot) (P/N KPC-488-2AT)
To Next Page
Loading...
Need help?
General
