To Next Page

To Previous Page

Getting Started 1-11

If you want the Model 2303 or 2303B to power up with the output on, you must use SAV5,

SAV6, SAV7, SAV8, or SAV9 as the power-on setup. For the SAV5 power-on setup, the power

supply will power up to the SAV0 settings, and the output will be on or off depending on the

output state when the setup was saved as SAV0. For example, assume the output is on and the

setup is saved as SAV0. With SAV0 as the power-on setup, the power supply will power up with

the output off. With SAV5 as the power-on setup, the power supply will power up with the output

on.

Power-On Setups:

NOTE

SAV5 through SAV9 are not available for the Model 2303-PJ.

Models 2303, 2303B and 2303PJ:

SAV0 (output off)

SAV1 (output off)

SAV2 (output off)

SAV3 (output off)

SAV4 (output off)

Models 2303 and 2303B:

SAV5 (SAV0 setup with output on or off)

SAV6 (SAV1 setup with output on or off)

SAV7 (SAV2 setup with output on or off)

SAV8 (SAV3 setup with output on or off)

SAV9 (SAV4 setup with output on or off)

NOTE

For GPIB operation, the setups are saved and recalled using the *SAV, *RCL, and

*RST commands. (See Section 8 for details.) The power-on setup is selected using the

SYSTem:POSetup command (Section 10).

Many aspects of operation are conﬁgured from the menu that is summarized in Table 1-2. Use

the following rules to navigate through the menu structure.

NOTE

The menu key is used to access the menu structure. However, if in remote for IEEE-

488 bus operation (“R” displayed below “ON/OFF”) the menu key returns the instru-

ment to LOCAL operation.

Keithley 2303 User Manual

Other manuals for Keithley 2303