1
Getting Started
Section 1 topics
Introduction, page 1-2 Menus, page 1-18
Capabilities and features, page 1-2 CONFIG menus, page 1-18
Organization of manual sections, page 1-2 Direct access menus, page 1-19
General information, page 1-3 Editing controls, page 1-20
Warranty information, page 1-3 Source and compliance editing, page 1-20
Contact information, page 1-3 Menu navigation, page 1-20
Safety symbols and terms, page 1-3
Unpacking and inspection, page 1-3 Password, page 1-22
Options and accessories, page 1-5
User’s manual, page 1-4
Reference manual, page 1-7 Interface selection, page 1-22
Additional references, page 1-7 GPIB and language, page 1-23
RS-232, page 1-23
Front and rear panel familiarization, page 1-7 Ethernet (Model 6221 only), page 1-23
Front panel summaries, page 1-7
Rear panel summaries, page 1-7 Error and status messages, page 1-22
Heat sink and cooling vents, page 1-12 Default settings, page 1-22
Front panel setups, page 1-24
Power-up, page 1-14 Remote operation setups, page 1-25
Line power connection, page 1-14
Power-up sequence, page 1-15 SCPI programming, page 1-22
Beeper and keyclick, page 1-16 Optional command words, page
1-29
Source preset, page 1-17 Query commands, page 1-29
Disabling the front panel, page 1-17
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
To Next Page
Loading...
