Model 6220/6221 Reference Manual SCPI Reference Tables 14-11
Return to Section 14 topics
:DCONductance Differential Conductance operation: 5
:NVPResent? Query connection to 2182/2182A: 1 = yes, 0 = no.
:NVZero? Query V-zero value acquired from 2182/2182A.
:STARt <NRf> Set start value (amps): -105e-3 to 105e-3. -10e-6
:STARt? Query start value.
:STEP <NRf> Set step size (amps): 0 to 105e-3. 1e-6
:STEP? Query step size.
:STOP <NRf> Set stop value (amps): -105e-3 to 105e-3. +10e-6
:STOP? Query stop value.
:DELTa <NRf> Set delta value (amps): 0 to 105e-3. 1e-6
:DELTa? Query delta value.
:DELay <NRf> Set delay (seconds): 1e-3 to 9999.999. 2e-3
:DELay? Query delay.
:CABort <b> Enable to abort test on compliance: ON or OFF OFF
:CABort? Query compliance sweep abort state.
:ARM Arm Differential Conductance.
:ARM? Query arm. 1 = armed, 0 = not armed.
:WAVE Wave function operation: 7
:FUNCtion <name> Select wave function: SINusoid, SQUare, RAMP
or ARBitraryX (where X = 0 to 4).
SIN
:FUNCtion? Query selected wave function.
:DCYCle <NRf> Set duty cycle (in %): 0 to 100. 50
:DCYCle? Query duty cycle.
:AMPLitude <NRf> Set amplitude (amps peak): 2e-12 to 105e-3. 1e-3
:AMPLitude? Query amplitude.
:FREQuency <NRf> Set frequency (Hz): 1e-3 to 1e5. 1e3
:FREQuency? Query frequency.
:OFFSet <NRf> Set offset (amps): -105e-3 to 105e-3. 0
:OFFSet? Query offset.
:PMARk Phase marker:
[:LEVel] <NRf> Set marker phase (in degrees): 0 to 360. 180
[:LEVel]? Query marker phase level.
:OLINe <NRf> Set phase marker trigger line: 1 to 6. 3
:OLINe? Query phase marker trigger line.
:STATe <b> Enable or disable phase marker. OFF
:STATe? Query state (on or off) of phase marker.
Table 14-6 (cont.)
Source command summary
Command Description Default Sec SCPI
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
To Next Page
Loading...
