TPES-B_TPEJ-B-BA-e-2319 50
Numeric input:
When the balance is in the measuring
mode, hold down the [S] key for about 2
seconds.
When <L. SEt> or <L1 SEt> is displayed,
release the [S] key
Last stored value for the lower tolerance
limit is appears on the display and flashes
(in this example: Weight value)
Press the [TARE/ZERO] key
<0 g> flashes on the display
Enter tolerance limit (Numeric entry: see
chap. 3.3.1)
An acoustic signal sounds and the
entered value is displayed briefly (in this
example: Weight value)
If the number of tolerance limits is more than 1:
The display shows <H. SEt> (or <L2 SEt>
… <L4 SEt>)
The last value stored for the tolerance
limit is shown and flashes on the display
Enter tolerance limits as described above
To Next Page
Loading...
