KERN PES 620-3M - Percent Weighing

TPES-B_TPEJ-B-BA-e-2319 34
11 Percent weighing
The application Percent weighing allows to check the weight of a sample in percent,
referred to a reference weight.
The reference weight can be recorded in two ways:
• Actual value setting method: Weighing the reference weight
• Numeric entering of the reference weight
• If you use a weighing container, it should be tared before setting the
reference quantity (see chap. 9.3)
• The readability of the balance automatically adjusts to the reference
weight:
Readability in %
Weight range of the reference weight
1
Minimum load <=
Reference weight
< Minimum load x 10
0.1
Minimum load x 10 <=
Reference weight
< Minimum load x 100
0.01
Minimum load x 100 <=
Reference weight
Model
Minimum load for percent weighing
TPES 620-3-B
0.1 g
TPES 2200-2-B
1 g
TPES 4200-2-B
TPES 6200-2-B
TPES 15000-1-B
10 g
TPES 31000-1-B
TPEJ 620-3M-B
0.1 g
TPEJ 2200-2M-B
1 g
TPEJ 4200-2M-B
1 g
 Select weighing mode <1. SEt 3>
(selection see chap. 9.4)
 The display shows <%>.
 Press and hold the [F]- key for about 2
seconds.