KERN PES 620-3M User Manual

85 TPES-B_TPEJ-B-BA-e-2319
Response:
A00:
Input successful
E01:
Input Error
E02:
Error at the time interval setting
E04:
Taring or zeroing cannot be carried out (range exceeded, weight
error, ...)
• Commands O8 and O9 are used to request data.
• After entering O8 or O9, the scale returns O0.
• Commands O0 to O7 are executed after activation until the scale is
turned off. The output settings are reset to factory settings when the
balance is switched on again.
• The commands OA and OB start the interval ouput. If they are entered
again, the interval output will be finished.
Weighing functions:
• The weighing function that can be activated by entering a mode
depends on the weighing application currently in use on the balance
(see mode table).
• Mode 3 can only be activated when the totalizing function has been
activated.
• If no unit B has been defined, mode 4 activates simple weighing
C1
C2
Code (C1)
Code (C2)
Significance
M
1
4DH
31H
Set mode 1
M
2
4DH
32H
Set mode 2
M
3
4DH
33H
Set mode 3
M
4
4DH
34H
Set mode 4
Mode
Simple
weighing
Piece counting
Percent weighing
Density
determination
1
Net weight value
(unit A)
Net weight value
(unit A)
Net weight value (unit A)
Error
2
Gross weight
value (unit A)
Piece counting
Percent weighing
Error
3
Total sum
Weight
Total sum
Quantity
Total sum percent
Error
4
Net weight (unit
B)
Average piece
weight
Error
Error

KERN PES 620-3M Specifications

General

Brand	KERN
Model	PES 620-3M
Category	Scales
Language	English