SYSTem:RELay Subsystem
Command Summary
SYSTem:RELay:CYCLes?
SYSTem:RELay:CYCLes:CLEar
SYSTem:RELay:CYCLes:FACTory?
SYSTem:RELay:CYCLes? (@<ch_list>)
Reads the cycle count on the specified channels. In addition to the channel relays, you can also query the count on
the Analog Bus relays and module relays.
Parameter Typical return
(none) +76289,+11055
Returns the cycle count on channels 103 and 113: SYST:REL:CYCL? (@103,113)
SYSTem:RELay:CYCLes:CLEar (@<ch_list>)
Resets the cycle count on the specified channels.
Parameter Typical return
(none) (none)
Resets the cycle count on channels 103 and 113: SYST:REL:CYCL:CLE (@103,113)
SYSTem:RELay:CYCLes:FACTory? (@<ch_list>)
Reads the factory cycle count on the specified channels.
Parameter Typical return
(none) +76289,+11055
Returns the factory cycle count on channels 103 and 113: SYST:REL:CYCL:FACT? (@103,113)
Keysight DAQ970A/DAQ973A Programming Guide 317
2 SCPI Programming
To Next Page
Loading...
