Keysight Technologies E5260 Series Programming Guide

Keysight E5260/E5270 Programming Guide, Edition 4 4- 5
Command Reference
Command Summary
Measurement
Execution
XE Performs measurements, and returns the measurement data; or recovers
from the paused state if the PA/PAX command has been sent. Not
available for the high speed spot measurement.
Staircase
Sweep
Source Setup
WT Sets the hold time, delay time, step delay time, and trigger delay time.
WI Sets the staircase current sweep source.
WV Sets the staircase voltage sweep source.
WM Sets the automatic sweep abort function.
Synchronous
Sweep
Source Setup
WSI Sets the synchronous current sweep source used with the WI or PWI
command.
WSV Sets the synchronous voltage sweep source used with the WV or PWV
command.
Multi channel
Sweep
Source Setup
WNX Sets the synchronous current sweep source or synchronous voltage sweep
source used with the WI or WV command.
Pulsed
Source Setup
PT Sets the hold time, pulse width, pulse period, and trigger delay time.
PI Sets the pulsed current source.
PV Sets the pulsed voltage source.
Pulsed Sweep
Source Setup
PT Sets the hold time, pulse width, pulse period, and trigger delay time.
PWI Sets the pulsed current sweep source.
PWV Sets the pulsed voltage sweep source.
WM Sets the automatic sweep abort function.
Quasi-pulsed
Voltage
Source Setup
BDM Specifies the detection interval, and either voltage or current
measurement.
BDT Specifies the hold time and delay time.
BDV Sets the quasi-pulsed voltage source.
Category Command Summary

Keysight Technologies E5260 Series Specifications

General

Brand	Keysight Technologies
Model	E5260 Series
Category	Measuring Instruments
Language	English